[Audriana]

how do i do 3 way calling on my panasonic phone

[H_O_T C_H_I_C_K]

To put the existing call on hold and make a new call, dial:1. RECALL BUTTON2. WAIT FOR DIAL TONE3. DIAL PHONE NUMBER4. WAIT FOR ANSWERThen to 3-Way Chat, dial:1. RECALL BUTTON2. WAIT FOR DIAL TONE3. PRESS 3To split a 3-Way Chat (put one call on hold), dial:1. RECALL BUTTON2. WAIT FOR DIAL TONE3. PRESS 2To switch between calls, dial:1. RECALL BUTTON2. WAIT FOR DIAL TONE3. PRESS 2To hang up one call and return to the call on hold, dial:1. RECALL BUTTON2. WAIT FOR DIAL TONE3. PRESS 1hope this helps. You press the same buttons on any landline phone.































[url=http://www.iinet.net.au/support/phone/guide/ug_3_way_chat.pdf]www.iinet.net.au[/url]

[shadowkat6927]

different phones may vary . usually you use the flash button to put the first call on hold a dial tone will come and then you dial the # and push the flash button again. also remember unless you have this service on your phone line there is a per call charge and make sure you do not have a 3 way block in place good luck