[Mick C]

My Fujitsu Siemens Scaleo Pc does not always boot up the monitor.It goes through the boot process and about halfway through the screen goes black and I get a message saying "no signal going to sleep"Restarting the pc seems to solve this problem and it boots correctly the second or third time.I dont think it's the monitor or cables as the logo shows up on the monitor when you turn it on and disconnecting and reconnecting the cables with the pc running makes no difference.

[sys admin]

i just you to flash BIOS(read meanual carefully) and updagte your bios will solve the problemeBRo

[ADEWALE A]

You might have just reset the resolution of your computer. As the system comes on and the logo shows, I will advice that you press F8 when you start booting up your computer. Select enable VGA and see if your system will start fully. If it starts, it is most like to start with a very low resolution option of Low 8bits, change this to true color of about 24bits or 32 bits and reduce the resolution option bar. Restart you computer, it should boot normally without any problem.Finally, Fujitsu Siemems have being known to have problems with boards especially. Boot I do hope this helps.